Dear Students, in preparation for the 3D printing workshop on Monday please read the message from MakerHub team below.

It is critical that you complete the pre-workshop training highlighted below.

Thank you! Looking forward to seeing you on Monday!

Regards, Dr. Greer

MakerHub Tinkercad Training Guidelines

As you are aware, this semester we will learn Tinkercad, a free, cloud-based 3D

design software. Prior to your first Tinkercad training session, please review this

document and come prepared to class. The Baruch MakerHub will lead the training

session.

Pre-workshop training:

1. Create a free account on Tinkercad (https://www.tinkercad.com).

2. Watch the short, 2-minute video “see how it works” under the learn tab.

3. Spend some time playing with Tinkercad software in “start learning 3D”

section.

=> It is critical that you complete these tasks prior to class.

Workshop location: Library building, 6th floor, Room 656.

Room 656 is a computer lab and each student will have access to their own

computer. Arrive a few minutes early as you will need to log into a computer and

launch all programs.

Directions to Library Room 656:

Enter the library, walk through the turnstiles in front of you, take the elevator up to

the 6th floor, enter through the turnstiles, turn right, and walk towards the help

desk. Room 656 is behind the help desk area so just walk around to our computer

lab.

Workshop dates:

Check the syllabus and course announcements for specific dates.

Once you arrive to the computer lab:

1. Find an open computer.

2. Launch Tinkercad and log into your account.

Note: You may bring your own computer if you prefer.